New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

New information on charging cast iron w/diamond

Posts

New information on charging cast iron w/diamond

#1

New information on charging cast iron w/diamond

Bill Tindall, E.Tn.

I happened to encounter a gem cutter and engaged him in a conversation on charging cast iron lapping plates with diamond. Best, he said, was a big agate polished to a convex form. But almost as good and easier to come by was to mount a roller bearing on a stick for an axel and roll the diamond into the cast iron. I had just pitched 3 new bearings in my trash. I have recovered them to use in this application.

Re: New information on charging cast iron w/diamond

#2

That is not new...

John in NM

I've been doing it for years to charge copper laps. I'm sure I've mentioned it here before.

Mine are on dowels with a cut and a wedge to hold the bearing, and the grit size written on the end with a fine tip marker.

I'm surprised however, that you found a stone cutter using a cast iron lap, those are old school. Most are using fancy tin alloy laps or ceramic for polishing with diamond. I use the copper ones for cutting (325 to 600 grit).

I knew a guy 20 years ago using 24" cast iron to polish petrographic thin sections. His diamond was in huge shaker bottles, dumped it on about like salt on a bland dinner.

Re: New information on charging cast iron w/diamond

#3

new to me

Bill Tindall, E.Tn.

I believe this is new information to be added to the recent discussion on preparing diamond charged cast iron. But if not, I stand corrected.

"I'm surprised however, that you found a stone cutter using a cast iron lap",..We didn't discuss what he did for stones so I have no idea what he used.

He did mention copper as a possibility for my needs. I found copper to be sticky for sharpening and abandoned it. But if someone can make it work, circuit boards provide a flat copper surface to charge. I have many if someone is successful and wants to buy them.

Re: New information on charging cast iron w/diamond

#4

Copper would be too sticky for you...

John in NM

It works best for cutting grits, up to 1200 or so. After that most stone cutters will switch to harder materials.