New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

More on benefits of steaming

Posts

More on benefits of steaming

#1

More on benefits of steaming

Bill Tindall, E.Tn.

I blundered into this reference while looking for something else. The results suggest that steaming, and maybe boiling, beech plane planks would be desirable for aiding drying.

DRYING EASTERN

HARDWOOD LUMBER

By

JOHN M. McMILLEN

and

EUGENE M. WENGERT

Forest Products Laboratory

Forest Service

U. S. Department of Agriculture

More recent studies in a number of schools

and laboratories have shown a number of

benefits[to steaming]. Moisture migration rates are increased

significantly, and drying times are

reduced. Drying rates were increased for northern red oak,

cherrybark oak, and sweetgum heartwood.

The drying rate at 50 percent moisture content

for these small specimens increased 34 to

75 percent for the oaks and 11 to 36 percent

for sweetgum heartwood. Steaming times

were in the range of ½ to 5 hours.

In another study with 1-inch-thick oak,

Simpson (1976a) found that the moisture gradients,

during drying after steaming 4 hours

at 212° F, were smooth curves. The natural

moisture gradients of the unsteamed controls

had inflections that indicated free water

movement was restricted.[not good, a stress inducing situation leading to cracks] Simpson’s work

showed that free water migration from the

center toward the surface was enhanced by

steaming.

Re: More on benefits of steaming

#2

Re: More on benefits of steaming

TomD

That isn't really new is it. I think I mentioned it twice. And as far as I know cracking in the process is reduced. But since beech is easy to air dry, that probably isn't a huge inducement, particularly as against the question which I though was why did they use it historically and I doubt they steamed it then.

Beech is also commonly used to make bent furniture. Steaming lumber is said to set the lignin and make bending harder to do, but in manufacturing you could bring the wet wood in, steam it and bend it all at one time.