New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Italian hingery

Posts

Italian hingery

#1

Italian hingery

Bill Tindall, E.Tn.




I saw this hinge in all the country furniture and even in larger house doors. I have never seen this style of hinge used before in furniture. It is reminiscent of the gate hinges I use in the sheep pasture. Apparently it wears in furniture better than I would have expected. All the doors I scrutinized remained well fitted with no sag from pin wear. Maybe it is yet another miracle property of olive oil applied to hinge lubrication :) , though none appeared to be lubed.

There must be a trick which was not obvious to me for installing this hinge to get its position correct . And then there is the issue of splitting as the pins are driven in and cinched. Clever Italian cabinet makers.

Like most country furniture this one was pine. Every piece of wood in Chianti seemed to be stained this color whether it was pine, oak or walnut.

Re: Italian hingery

#2

Jack Guzman from Maine

Re: Italian hingery

Jack Guzman from Maine

Bill,

That is similar to the hinges used in very old chests.Instead of a pin it is two loops linked through each other, one in the lid and one in the back of the chest. They attach in the same manner,passing through and being bent over. I have seen a web site on how to make one of those with modern materials. I don't remember where I saw that but I have seen the hinge on several chests found in Maine homes.---Jack

Re: Italian hingery

#3

Re: Italian hingery

William Duffield

They're called snipe hinges or gimmals. Peter Follansbee wrote an article on how to install them in a Bible box that was published in the Spring, 2009 issue of Woodwork magazine. The woodworking association I belong to had a group build of 17th Century Chester County Bible boxes. Some of the boxes that were built used the snipe hinges.

If you search the Internet for snipe hinge or gimmal, you might turn up more installation technique information

I believe Popular Woodworking now owns rights and sells a DVD of the whole collection of Woodwork.

Re: Italian hingery

#4

Re: More Hinge Info

William Duffield

Peter Follansbee also published instructions on his blog, Joiners Notes, on December 14, 2011.

https://pfollansbee.wordpress.com/2011/12/14/setting-gimmals-you-might-know-them-as-snipe-bills/

Horton Brasses sells reproduction snipebill hinges.

http://www.horton-brasses.com/H-61.asp

They used to have an installation diagram, but I can't find it today.

Re: Italian hingery

#5

not the same hinge

Bill Tindall, E.Tn.

The Italian hinge is just like a typical gate hinge with a vertical pin that goes into a hollow cylinder.

Re: Italian hingery

#6

Re: not the same hinge

William Duffield

Sorry for the distraction. I provided info on the hinge Jack described, not the one you photographed. I've also only seen your hinge on farm gates.

Re: Italian hingery

#7

Jack Guzman from Maine

Re: not the same hinge

Jack Guzman from Maine

I'm sorry if I caused confusion. My point was that the cylinder side of that hinge is similar to a snipe hinge and would install in a like manner. Study of the other's intallation method may shine light on your hinge's method of installation.---Jack