Easy plane blade back flattening
Chuck Bjorgen
Earlier this week I brought home another No. 4 Stanley found on Craigslist. I started the blade back flattening chore the hard way, the one that is rough on fingers and not very productive. This cutter had a rather pronounced belly that would not easily go away. David Weaver in his “Making a Wooden Plane” video series showed his jig that helps with the flattening of plane blade backs. Remembering David’s jig, I threw my own version together this morning and was simply astounded at how much easier this chore became for me.
I used a chunk of 2 x 4 that I’d flattened and 5/6” bolts and nuts with oversized washers. The bottom holes were inset with a Forstner bit to keep the bolt heads and washers from riding on the work surface. I used a series of DMT X-Course and EZ-Lap diamond stones for about 15 minutes to complete the job. During the week I might have spent a total of an hour getting sore fingers but no results without this jig. The beauty of this jig is that it seems to concentrate all your effort onto the blade and stone. Thanks for the tip, David.
Here’s my version:




