New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Auger Bits

Posts

Auger Bits

#1

Auger Bits

Kevin French

I've been doing a reorg of my small shop, moving some of my hand tools closer to the area where I might use them more often. I was collecting my braces and sorting thorough all my bits and came across a few I need to ID

 photo P1200978.jpg

The one on the left is a tapered square bit is a Reamer?

Middle one appears to be a long bladed screwdriver

On the right I'm again guessing a reamer, it has a flat face with a rounded back.

 photo P1200977.jpg

Spoon Bits?

Re: Auger Bits

#2

Re: Auger Bits

TomD

Spoon bits have a rounded end like a duck's bill, and they cut off the 3 o'clock to 6 o'clock of the end. I can't tell from the picture, but the bit second to last looks like a type that cuts off the side of the end, though the ones I have of that type are normally threaded at the tip. I only bought some when they were recommended by Larry in his hollows and rounds video because they cut from the side, and therefore have very little chance of splitting out the hole one drills to start the inletting for the blade.