A puzzling design for a square *LINK*
Bill Houghton, Sebastopol, CA
I've been helping my son clear out a garage - an older gentleman died and the family needs the garage emptied to store furniture while they rent the house.
This was one of the finds from the second week of clearing, a square and bevel from the Fred C. Breul Tool Works of Connecticut, stamped "Fox's" and "Patented 1921."

This sure looks like one of the ancestors of the modern aluminum (or plastic, gag me!) one-piece speed square. It may not be obvious from my not very good picture that the vertical portion of it, as it appears in the picture, is a stock, with flanges on each side that would be held against the edge of the work, as with the stock of a try square.
But I'm puzzled by the extension of the top beam (the square part rather than the beveled part) past the stock. When would this be useful?
There's not much on the Internet about this design. I found one discussion in the OldTools archives, but it focuses on the patent history rather than the use of the tool. All the other Internet listings are just various auctions/sales of other examples of the tool.
OldTool Archives post on the subject







