Chisel follow-up - The Kell honing guide
Guillaume Dery
Hi gang, following up on my Mortice chisels TOTT find and ongoing rehabilitation.
Now that the backs are (finally) flattened, I still need to sharpen these and fix the primary bevel. They are badly chipped and out of square and have a variety of issues. While I can and often do freehand my smaller chisels and plane blades, this doesn't extend to suckers this big and top-heavy or restoring geometry.
I am definitely going to jig these up. Looking at the honing guides and polling a few people, I have landed on the Kell honing guide as being well suited for this. My existing Veritas and eclipse guides can't handle the chisels due to the huge cross-section. Never mind how well it could hold the, I can't get the in, period.
So a 2-part question for owners/users of the Kell guides:
1- What is the working depth on the large wheel #2 Kell guide? (I am pretty sure that the 1/2" pig-sticker is just about an inch in cross section) I would hate to buy something for a specific purpose only to have undersized it.
2- Can anyone point me to a Canadian or US source I can order the appropriate Kell guide from? Ordering direct from Richard Kell is out as I have a philosophical difference with PayPal and he won't accept any other form of payment (not that I blame him, I understand his reasoning, it just means I can't do business direct with him, much as I'd like to). I did note that they seem to have them at Joel's toolsforworkingwood but they seem to be the old model with the small wheel (based on the accompanying image on their website at any rate).
Thanks in advance all,
Guillaume



