New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Can this be repaired?

Posts

Can this be repaired?

#1

Jack Guzman from Maine

Can this be repaired?

Jack Guzman from Maine



I use this brace in windsor chair building. I keep commonly used bits in dedicated braces so I just need to grab the right one when I need to drill a hole. The other day the handle of this one came off in my hand. Is there any way to reattach it so it works? There is a metal sleeve still in the handle but I can't tell by looking inside or at the brace itself how it was held in. I can't glue it in because it has to turn freely.Anybody got a picture of the inner parts that shows how they work?---Jack

Re: Can this be repaired?

#3

Re: Can this be repaired?

Tom in Toronto

It looks as though the clip would have gone on from the top, under the medallion, but somehow the whole mess came through the grip with sufficient wear. Everything is fixable, but I can't be sure what you need in this case, depending on which parts are worn.

Re: Can this be repaired?

#4

Re: Can this be repaired?

Kevin French

What make is it?

Re: Can this be repaired?

#5

Jack Guzman from Maine

No maker's mark


Re: Can this be repaired?

#6

Re: Can this be repaired?

charlie belden

Just from looking at the photo you provided, it appears the top of the shank of the brace is slotted, has a groove around it and the end rounded. It also appears that there's a metal insert in the handle.

from that info, here's my guess as to how the handle was held on the shaft.


If this is basically how the handle is held onto the brace, it seems the "C" clip broke / wore out

or

the notchinside the metal insert, that the "C" clip snapped into, wore and could no longer hold the "C" clip.

If the "C"clip failed, you may be able to find a replacement.

If the groove in the metal sleeve wore out you could conceivable re-turn a the oridinal groove deeper, and get a corresponding larger OD diameter "C" clip.

OR

You could split off the original handle, check out the inside of the insert sleeve and see if there is a groove for the "C" clip, grind the groove deeper with a flex shaft and small metal bur - go look for a "C" clip and turn a new handle.

OR

Go hunting for a new brace - which would probably be a lot more fun ; )

Re: Can this be repaired?

#7

Jack Guzman from Maine

Figured it out!

Jack Guzman from Maine

I looked at it closer and noticed a washer in the bottom of the hole bigger than the hole. Now how did they get that in there? On the top of the knob I could just barely make out the outline of a plug. It was a good fit and the grain was a perfect match. I put a bolt into the hole and tapped it and the plug popped right out.

Now all I have to do is put it back together and peen over the end of the brace to hold onto the washer and put the plug back.---Jack


Re: Can this be repaired?

#8

Jack Guzman from Maine

Re: Can this be repaired?

Jack Guzman from Maine

Charlie,that c-clip idea was my first thought. That was why I started looking into the hole. The washer threw me until I figured out how to get the top off.---Jack

Re: Can this be repaired?

#9

BINGO!