Re: The Chair - Arms and Backrest begun.
Tom in Toronto
Well, as far as the epoxy is concerned I don't think that is going to help much, Epoxy is great glue but it's main magic in this app is to fill gaps. So within reason, if you goof the joint it will make up for gaps, it can fill a 6mm gap, but if the fiber is going in the wrong direction or missing, it isn't going to help there.
You do seem to have seriously bad runout. In the arms your run-out is in all the wrong places compared to the sample chair. The back piece is harder to read in your sample. But one picture shows only a few cathedrals on one side of the back rest, so it looks like their grain runs pretty well around the piece , which is quite a trick.
Your grain orientation will weaken the chair, my guess is mostly in the resting one's hands on the rear rail and leaning forward (thereby pressing down) mode. It should be pretty strong in the leaning back mode, but then it also depends on racking, which is hard to see without having the chair in front of one.
Additionally for a lessor soul than you the shaping on the back could be made a little more complicated due to grain reversals. And the back of the joint will probably have more of an end grain colour to it.