Many thanks to the collective knowledge here
Bill Houghton, Sebastopol, CA
We're chugging along on our remodel. I had asked a couple of questions over the last month about how to trim the carpet pad for the new carpet, and got great advice from Jack Guzman directing me to a new tool to me, a carpet knife; and from John Sayles, about sizing the pad relative to the carpet. These two suggestions made what had been a huge hassle with other carpet pads into a simple ten minute project. Thanks much to you two, representing the collective knowledge of this community!
The picture below shows the carpet, just after putting it down. The slight "lifts" at the far edge are where plastic wrap was keeping it from unrolling in transit. They're now weighted down with books (Tage Frid's furniture series and two of Garrett Hack's books on handplanes and classic tools), which worked on the (not visible) near end, where the center of the roll of carpet was curling. Also included is the gas heater and its surrounding tile. As you can see from the picture, we're moving in before the trim is done; this will make it harder to trim out, of course, but it will allow us to use this room, which looks out on the backyard, through the gloomy winter.





