New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

What'd I find?

Posts

What'd I find?

#1

What'd I find?

Kevin French

I bought this bit and a brace (like I need another brace but they came as a pair) today

It has MF Co. Made in USA, No. 82

My first thought was it's a Miller Falls circle cutter for sheetrock. The cutters are light duty, but the flat part of the cutters are facing inwards.


Re: What'd I find?

#2

Stephen Shepherd

Re: What'd I find?

Stephen Shepherd

Looks like a washer or gasket cutter for leather.

Stephen

Re: What'd I find?

#3

Re: What'd I find?

Bill Houghton, Sebastopol, CA

I'm not sure if this is a gasket cutter used in plumbing or not - if it is, it's one of the best I've seen yet. Before tapered threaded fittings, as in galvanized (or black) plumbing, a lot of plumbing was done with flat, round flanges bolted together with a gasket* between. Indeed, large systems are still done this way. I've found several gasket cutters over the years; they usually have the same center point as yours, with two L-shaped cutters, along the lines of some Japanese mortise gauges. Yours is fancier.

*Probably, as Stephen says, leather in the early years. More recently, gaskets have been of various composites, depending on the plumbing use - water, steam, etc.

Re: What'd I find?

#4

Re: What'd I find?

William Duffield

…the flat part of the cutters are facing inwards.

Aren't the cutter heads reversible? Otherwise, there wouldn't be any need to mark the graduations all the way to the ends of the bar.

Re: What'd I find?

#5

Incidentally

Bill Houghton, Sebastopol, CA

In use, one of the cutters would cut the inner diameter, and the other the outer diameter, of a donut-shaped gasket. I pointed to plumbing, but it occurs to me that there are other applications for circular gaskets - wells, leather rear axle seals and some other automotive applications, etc.

I can picture, on big jobs, the apprentice getting the dimensions for the gasket and standing there, brace in hand, cutting it out, while the journeymen prepared the joint.

Re: What'd I find?

#6

Re: Incidentally

Kevin French

Yes William I checked and the cutters do reverse which is consistent with Bill's last post.