New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

index finger on closed tote

Posts

index finger on closed tote

#1

index finger on closed tote

Steve Voigt

what's your preffered position for your your index finger on a closed tote?

I'm making a closed tote for a shopmade fore plane. I've made a couple totes on other planes. They're comfy, but one thing is not quite right: I can almost, but not quite, curl the first joint of my index finger over the front of the tote. I think I need to either make it easier to curl my finger, or make it impossible.

So, do you curl your finger around the front of the tote, or extend it straight out?

Thanks,

Steve

Re: index finger on closed tote

#2

Re: index finger on closed tote

Bill Houghton, Sebastopol, CA

Even on an open tote, I tend to curl my finger around the frog and iron on smaller planes.

Re: index finger on closed tote

#3

craigd

Re: index finger on closed tote

craigd

I prefer all fingers around the tote. The second reason is if I have the index finger on the frog, I tend to push the blade sideways (I don't eat spinach and I don't put a wrench on the lever cap).

Re: index finger on closed tote

#4

Re: index finger on closed tote

William Duffield

Pointing with your index finger is "built in." Most animals don't get the concept of pointing; a lot of dogs get it, but not all of them; recent reports indicate that elephants "get it." It is therefore useful, whether sawing or planing, if you need to guide the direction of the tool, to not wrap your index finger around your tote, but to extend it. The key is whether you are guiding the tool, or it is self guided or guided by a jig. Evidently, at some time in the Twentieth Century, Disston regressed to a subhuman state and lost this concept. You'd think they would teach this in the first lecture of Ergonomics 101.

Re: index finger on closed tote

#5

Re: index finger on closed tote

Wiley Horne--So. Calif.

Hi Steve and all,

I agree with Sir Wm. Pointing is good with sawing too.

Specifically to your question about grip, I had to go pull out a couple of closed tote woodies to see what I do, and why. I tested with a C&W try plane and fore plane. Herewith the results....

1. Curling the finger over. You mentioned it being natural to want to curl your finger over the top. Like this, maybe...

http://www.flickr.com/photos/78661951@N07/10250300263/in/set-72157635030917606

When I first picked up the try plane or the fore plane, holding it up with elbow bent at 90 degrees or so--like you do when you just pick something up to look at it--I also let my forefinger cross over the top. It seemed natural. The reason I think is that the whole hand is making a curl--the little finger is curled around, all the fingers want to curl together.

But things change when I put the planes on the bench in planing position. Now I'm not holding the weight of the plane--the bench is supporting the plane, and I'm going to push it, which is different. As I get ready to plane, the hand shifts to this position, a two-finger grip. Now the little finger and index finger want to be straight together, the two middle fingers around the tote:

http://www.flickr.com/photos/78661951@N07/10250268763/in/set-72157635030917606/

[The hand looks a bit distorted in these photos because i'm twisted around trying to take a picture of the left hand with camera (phone) in right hand.]

2. Bench height and tote shape. I tested all this on two benches, one at 29-1/2" height; one at 36" height (I'm 5'11"), and got the same result: I always want to use the two-finger grip for planing, with little finger and index finger straight. I also checked one of Konrad Sauer's panel planes, which has a higher tote and room for fingers, and got the same result.

On lower benches, and especially if the plane has a longish horn, there's no option. You can't curl your fingers, because the lower bench height and prominent horn are breaking your wrist! But even on the 36" bench, where there was no wrist/handcurl fight going on, I still wanted to point the index and little fingers.

In summary, test the matter on your bench with another plane that you already use. What do you actually do? In answering this, consider what kind of horn you're going to put on the tote of the fore plane.

Hope this helps!

Wiley

Re: index finger on closed tote

#6

Re: index finger on closed tote

Steve Voigt

Thanks for chiming in everybody, and thanks for the pics Wiley! I've never tried a two-fingered grip. Looks interesting.

I posted the same question on another forum…it appears that "pointy finger" is the overwhelming preference.