New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Sigh

Posts

Sigh

#1

Sigh

Ron Harper

Watched an episode of Tommy Mac this weekend where he and his buddy made a workbench that would certainly be a good tool for anyone. The sigh come in when some mortises were being cut. Tommy said his buddy was "old school" and would do it the old time way. He proceeded to get out a power drill and drill holes and then pare. Old school? Sigh

Re: Sigh

#3

50-50

Bill Houghton, Sebastopol, CA

At least he used a chisel. Certain other television woodshow personalities would have hauled out the mortising machine.

Re: Sigh

#4

Tommy Mac did


Re: Sigh

#5

Re: Sigh

Brian from Monument

Would you have a sigh if he had used a hand powered auger to drill the hole and then square it with a chisel?

Re: Sigh

#6

Nope


Re: Sigh

#7

Re: Nope

Tom

So it is all about the electrons, not the skill? It takes more skill to run an electric drill, though not a drill press. Certainly drilling holes is traditional enough. Timber framers seem to prefer this method. To me, paring takes more skill than chopping, I just can't chop a 2" mortise in some hard oak.