New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

"hand made" desk parts

Posts

"hand made" desk parts

#1

"hand made" desk parts

Bill Tindall, E.Tn.


This has been an unusual project. For one, I made the top first, for reasons I can't reconstruct. I prefer fitting a top to the rest but now I am faced with fitting the rest to the top. More risky.

Leveling the stinging was problematic in that if I created black dust it would lodge in the white ash pores, irretrievably.. This problem was solved by sealing the ash with shellac, and then scraping it all level. The shreds from scarping were easier to blow our of the pores.

There was discussion of string size. This is a modern piece and I wanted a bold black border. I used 3/32".

I was advised to make a router jig for the legs and that could have been a good idea. But I thought that I could make the legs in the time to make the jig. I am confident band sawing and knew I could split the line defining the leg shape. The outside curve was uneventfully planed. I thought I would sand the inside curve. That didn't work out. Spoke shaving ash, especially when the grain was steeply rising was not uneventful. Even with a freshly sharpened blade and the finest cut I could set it was a test of strength to pick up and continue a shaving throughout the arc. Ash is tough stuff.

Maybe for the first time ever for me this desk is going to be made without the use of sanding.

Re: "hand made" desk parts

#2

These "in progress" reports are very educational

Bill Houghton, Sebastopol, CA

Thanks, Bill - and Derek, who also posts reports of work in progress - for your willingness to share your experiments, experience, and learning.

Re: "hand made" desk parts

#3

Amen