New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Tips on taking apart MF#118 Breast Drill?

Posts

Tips on taking apart MF#118 Breast Drill?

#1

Dominic in Bucks County PA

Tips on taking apart MF#118 Breast Drill?

Dominic in Bucks County PA

I have a Miller Falls No118 Breast Drill that I am attempting to take apart to clean and lube. Specifically in the area shown in the photo below. While the shaft does turn freely, I want to remove it and get to the bearings at the spur gears. The knurled nuts will move only a quarter turn and then stop.

I've tried soaking in PB Blaster and applying localized heat (via a torch) with no real improvements. Before I go and use too much force and destroy this tool I was wondering if anyone here knows how to take this drill apart. I have a feeling that I'm missing something here. Like there is something else I need to loosen and this'll allow the knurled nut to turn.

I've emailed Wiktor Kuc (http://wktools.com/) with this information but haven't heard back from him.


img

Re: Tips on taking apart MF#118 Breast Drill?

#2

Re: Tips on taking apart MF#118 Breast Drill? *LINK*

Patrick Gibbons

Are these perhaps the take up nut that is mentioned in the catalog? The link below is an MF catalog from 1925. On p. 66 is your drill. Google repair of these and maybe you'll find something. A quick look showed me more on eggbeater drills than breast drills. As Augustus Caesar said, "make haste slowly".


http://www.roseantiquetools.com/sitebuildercontent/sitebuilderfiles/millersfalls1939.pdf

Re: Tips on taking apart MF#118 Breast Drill?

#3

Dominic in Bucks County PA

Re: Tips on taking apart MF#118 Breast Drill?

Dominic in Bucks County PA

After getting an email from Wiktor, where he pointed out that I had to remove a pin that was located in between the teeth of the pinion gear, I got this drill apart last night. I soaked most of the pieces in Evaporust and cleaned them off tonight.

So now I need to buy some bearing grease (I'm all out) and reassemble it.

Re: Tips on taking apart MF#118 Breast Drill?

#4

I should have guessed; makes sense

Patrick Gibbons

Post finished pictures.

Re: Tips on taking apart MF#118 Breast Drill?

#6

What plans do you have for it?