New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

mass producing drawer slips

Posts

mass producing drawer slips

#1

mass producing drawer slips

Bill Tindall, E.TN.


This sketch may clarify how I make the slip stock. Drawers are rarely more than 22" deep so I begin by whacking off about a 45" piece of thick 5/4 or ordinary thickness 6/4 poplar. I clean up both faces with planer, round over each corner and cut the 4 grooves. Then saw the 2- slip assembly off each end followed by splitting apart the two slips. Each time I do these steps I get enough slips for 4 drawers.

The only reason I can think of to put tenons on the ends as described by Derek is to aid alignment. The alignment blocks I describe substitute for this feature.

Re: mass producing drawer slips

#2

acknowledgement

Bill Tindall, E.TN.

I can thank James Watriss for kindling the idea to "mass produce " the slip stock from a much earlier exchange on the topic.