Veritas Miniatures
Jack Guzman from Maine
I have all four of these neat little tools. I have tried each one on a scrap of wood and found that they are all totally functional. This is the first time I actually needed their unique size on a job. I repaired a high chair. The tray split in half with the grain. It has holes left from an old repair that used metal L brackets to hold the pieces together. After this it was repaired again by putting dowels in both ends. These were poorly lined up and didn't hold the halves together. I removed the dowels,planed both edges of the tray and glued them together.Once the glue set I added dutchmen to the bottom surface to span the split. I cut the butterfly shaped dutchmen with a small handsaw. I cleaned the edges with a paring chisel. One end was rough from the saw so I trued it with the mini block plane.Also one face. To make the mortise I looked to my router plane with a small bit but the base of the bit was too long to be of any use. Then I tried the mini router. Perfect. Just the tool for the job. This little tool works very well for smoothing small mortises. I will be using it more often I can see now.---Jack



