New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Plane Iron Question

Posts

Plane Iron Question

#1

Robert Tutsky

Plane Iron Question

Robert Tutsky

I am trying to smooth out a highly figured maple board with a Stanley #4 and having problems with the surface tearing out terribly. I have never done it but would a slight back bevel on the iron improve the planing process? And if so what degree should I go for, 5 degrees? I have the iron very sharp and the plane is set up the best I can get it. I know it would be a pain in the you know what to remove the bevel if it doesn't work, so should I leave this iron alone and purchase another iron and alter that one?

Re: Plane Iron Question

#2

Re: Plane Iron Question

John Pappas

You must read the splendid article by David Weaver in the Hand Tools and Techniques section on 'Setting a Cap Iron". You will be amazed, as I was, at the results. A five star article.

Re: Plane Iron Question

#3

Robert Tutsky

Thank You John!

Robert Tutsky

Okay after going through that article you mentioned I went back and fussed with the chip breaker and set it up as mentioned and what a dramatic difference! No tear out at all... the board is smooth as glass. I am in love with my #4 all over again. Now to go over all of my other planes and monkey with them also. Again, thank you for the heads up on the info.

Re: Plane Iron Question

#4

Re: Plane Iron Question

eliot d

How about trying to do it with a card scraper? I have found these to be excellent tools for your type of problem.

Re: Plane Iron Question

#5

Robert Tutsky

A card scraper is fine but

Robert Tutsky

I needed to flatten one corner a bit and I figured the plane could do a better job of it and faster also.

Re: Plane Iron Question

#6

Kato and Kawai

Bill Tindall, E.Tn.

go find the discussions in this Forum and stuff in the Articles section on Kato and Kawai. It will be the solution to your problem.

Re: Plane Iron Question

#7

Robert Tutsky

Re: Kato and Kawai

Robert Tutsky

Yes Bill, I have read through the article and found it fascinating. After doing so I spent some time with my plane and it made a world of difference. No tear out at all on a gnarly tiger maple board. I have been enlightened. When time permits I will go through my other planes and adjust them also. Thanks.