New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

three blades, three chipbreakers, one plane.

Posts

three blades, three chipbreakers, one plane.

#1

bridger

three blades, three chipbreakers, one plane.

Bridger

today I hung a door. for reasons I won't go into here I knew I'd need to do some heavy planing, so I brought three cutters set up with chipbreakers for a #5 plane. one with a heavy camber(use a short chipbreaker for that one), one with a little camber and one sharpened straight acrosswith the chipbreaker set close. this setup worked so well I'm thinking of a way to make a travel case for multiple blade/chipbreaker sets. just a little fiddling with the depth setting and lateral adjustment, plus a turn or two of the lever cap screw is all you need to completely change the performance of your plane from near-scrub to near-smoother.

Bridger

Re: three blades, three chipbreakers, one plane.

#2

Re: three blades, three chipbreakers, one plane.

Patrick Gibbons

That's the thrifty and space-saving way to do it. It's really good to hear it worked for you. A canvas roll would be a space saving way to carry the sets.

Re: three blades, three chipbreakers, one plane.

#3

Re: three blades, three chipbreakers, one plane. *LINK*

Bill Houghton, Sebastopol, CA

A thorough development of an old idea - and therefore a new idea. Good thinking.

I don't know if Lee Valley's plane cases would work (linked below), but I'm inclined to agree with Patrick that a canvas tool roll would be simplest, although you'd probably have to make it yourself, unless you wanted to buy a chisel roll and remove the stitching between adjacent pockets until you got the width you needed.


http://www.leevalley.com/US/Wood/page.aspx?p=69539&cat=1,41182

Re: three blades, three chipbreakers, one plane.

#4

Question

Al Goldstein

Wouldn't the plane need an adjustable mouth? Scrub planes need a wide mouth and smoothers need a narrow mouth.

Re: three blades, three chipbreakers, one plane.

#5

bridger

Re: Question

Bridger

the mouth is pretty open on this plane. I suppose you could say that's why I'm calling it near-scrub and near-smoother performance rather than scrub and smoother performance. a #5 is a bit long for a smoother and a bit wide for a scrub, too, but all in all it worked out well for the softwoods job I was doing. if the chipbreaker is set close the tight mouth is not so important. for this many blades one plane setup a thick blade could be used for the smoother blade to close up the mouth for that operation while leaving it open for roughing out with a thinner blade that leaves the mouth more open.

Re: three blades, three chipbreakers, one plane.

#6

Unlike 3 irons in-waiting

Bruce McCrory

Trying to find immediate use for my LV LAS extra irons. I think I will cut a Stanley 220 at the desired bed angle, and sweat new shoulders onto it. Then make another for the third bevel angle.