We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
I've not given any thought to making adjustments to the frog on a Bailey style plane from one planing session to another, either softwoods or hardwoods.
Is this a common practice for you as well? If not, what has been your experience with the frog adjustments and what suggestions or guidelines could you offer? Thanks in advance, Tom.
If I have trouble with a plane that is new to my shop and I think it may be the frog position, i will check it, and adjust it, if needed. Then it stays put.
Set it and forget it. It matters that it's tight and stable, but not that it's terribly easy to reset it all the time.
The only time I moved the frogs intentionally on any of my planes after their first set was when I figured out that it was more useful to have a properly set second iron than it was to have a tight mouth.
I've spent a fair amount of time playing with the mouth adjustment on Stanley [-like] planes (45º), and cap iron placement is way more important. In fact, I'm much more likely to set the frog too close, which causes clogging (as the geometry of the front of the mouth interferes with the cap iron).
I also did a quickie test on a 55º infill and the mouth opening was pretty irrelevant.
Here is a composite photo of five planes that perform about the same, the most open mouth is about 1/8".