New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

widening dados

Posts

widening dados

#1

widening dados

Jerry Gibbs

What is the best way to slightly widen a dado? I am fitting some plywood into dados that are tight. I have been using sandpaper fitted over a smaller piece of wood. The dados are about 7/16 and are in poplar and plywood. Is there a more elegant and efficient way? Jerry

Re: widening dados

#2

Side rabbets?

John in NM

There are a variety of planes made for this, from LN, Lee Valley, Kunz, and Woodriver.

Re: widening dados

#3

I have the Stanley 79, but

Bruce, a MN Galoot

I suspect the LV version is a lot better. The Stanley works ok.

Re: widening dados

#4

Re: widening dados

Bill Tindall

All these plane ideas are theoretically interesting but I presume you have a need at hand.

simple way: router and a fence

Not much harder way: fence and a chisel. I watched Will Neptune accomplish this feat to make a tapered dado and it went surprisingly quickly. The secret to doing it quick is the chiseling technique which I will try to explain.


In the picture I am making a dado into a dovetail socket, but the technique is the same. The tip of the chisel is used to shave about 1/8" portion of the stuff to be removed. Start with angle cut but as soon as practical transition to downward thrusts of the chisel that make an arc path. You will soon get the feel for how much can be removed with each arcing thrust of the chisel. It takes not a minute to travel the 3" depth of this dovetail socket.

Re: widening dados

#5

Re: widening dados

Andy Lincoln,in Dearborn MI

Jerry,

A side rabbet plane would work in this instance.Big difference though in cutting the poplar vs plywood.

How about a small rabbet on the plywood going into the dado?I'd bet that you have something on hand that

would make it possible,neat and efficient.

Andy

Re: widening dados

#6

Agree, and

Wiley Horne--So. Calif.

knife the line first to avoid splintering the ply. Otherwise, what Bill T. said--fence your chisel.

Wiley

Re: widening dados

#7

Re: Solid Advice, but Bill...

TomD

wasn't it you, who a week or so back was wondering who needed a wooden block to guide a chisel while dovetailing? And is that a massive slab of bench top you are working on there?

Re: widening dados

#8

Jack Guzman from Maine

Me too

Jack Guzman from Maine

I have been using my 79 for just that job for years and it's quick and easy to creep up on the right width. I never needed anything else.---Jack

Re: widening dados

#10

thanks all


Re: widening dados

#11

Re: Solid Advice, but Bill...

Bill Tindall

You just noticed that it is thick (2 7/8") !?! A quick check revealed that I have posted 28 pictures of making stuff on this bench over the years. It was constructed from some 12/4 poplar I had left from a special order of 12/4 for a customer. The lumber was 14' so the bench became 7'.

Similarly, and to clarify, the technique for constructing a chest of drawers with housed dovetails has been previously posted several times as part of discussions on these projects. In spite of the fact that I have done dozens of these sockets I would have difficulty judging 14 degrees without the guide block. But for 0 degree cuts where undercutting a degree or two is desirable I do not find a guide block necessary.