Modular Sticking Board
William Duffield
Inspired by Matt Bickford’s Mouldings in Practice, from Lost Art Press, and a couple of recent jobs for custom architectural mouldings, I decided it was about time I stopped kludging together a new sticking board every time the height, width or length of the needed moulding changed. I also wanted a sticking board that I could reconfigure without tools, and that would not be degraded by reconfigurations (as would happen if it were assembled with screws or nails). To accommodate longer runs of mouldings, I needed a sticking board that is longer than my workbench.

This is the modular sticking board that I designed and built. For its construction, I used the Festool Domino joining system, which is quick, accurate, and it makes sturdy, precise joints that are quickly and easily reconfigured. I suppose doweled joinery or even KD fasteners could be used in place of the Domino mortises and tenons, but the appliance would not have been as accurate, or as quickly constructed.
My sticking board is made from four pieces of four-squared tulip poplar: a base and three fences, a handful of beech tenons, and another handful of flathead wood screws. Using a countersink, I installed a row of five wood screws in each end, to accommodate various fence positions and moulding widths, and so I could plane in either direction. The base and fences are finish jointed and planed to a thickness of about an inch. The fences are about an inch and an eighth wide, and the base is about four and a half inches wide. None of these dimensions are critical. Just use the straight lumber you’ve got available, or even some plywood or MDF (a.k.a. termite barf).
My bench is about 7’ long, with a patternmaker’s vise on one end, so I can fit an 8’ sticking board between the planing stop on one end and a dog in the fully opened vise.

At several locations (four) along the length of the base and fence, I cut mortises in the base and fences. A column of five mortises in the base allows the fences to be adjusted for the width of the moulding. Two of the fences have a mortise on the bottom and on the top surface, and the third fence has a mortise only on the bottom. This allows one, two, or three fences to be stacked to accommodate mouldings of different heights. The fences can also be moved closer to or further from the front edge. Three heights by five horizontal positions accommodate fifteen different moulding sizes.

The m&t in the top of the first fence and bottom of the second fence are offset a couple of inches along the length of the sticking board so that the tenons would not interfere with the tenons above or below, because the mortise depths turned out to be just a little more than half the thickness of the fences.

I also implemented an alternate mounting method, to clamp the sticking board to the front edge of the bench instead of at both ends. It uses the Domino again and Festool 489570 Quick Clamps. Alternative strategies would include drilling half inch holes with a drill press or brace and bit, and modifying a cheap F-clamp with a grinder to fit the hole. I used a 14 mm mortise cutter in the Domino. If you only have a DF 500 with a 10 mm cutter, you’ll need to adjust the fence and punch two partially overlapping mortises, one above the other.







