New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Neat vise design

Posts

Neat vise design

#1

Neat vise design

Bill Houghton, Sebastopol, CA

I picked this vise up today at a yard sale:



Interesting design. It's clear the maker intended you to use the front edge of the bench as the rear jaw of the vise. I thought for a minute that this was a well-done later solution, as the rear "jaw" appears to be channel stock. However, there's a nut cast into the "channel," which I thus conclude is a casting, not a piece of steel stock, and probably original. 10" wide jaw, 9" opening.

All I can find on it as "Made in U.S.A." and, by the dog slot, "2433." No maker name.

Re: Neat vise design

#2

I have a similar one...

John in NM

That uses the edge of the bench as the inner jaw. I haven't looked too closely at it though, a friend of mine gave it to me and I don't currently have plans to use it. I seem to remember it has a patent date on it, so it would probably have a manufacturer's name as well.

Re: Neat vise design

#3

Re: I have a similar one...

Patrick Gibbons

You suck. That's a fantastic find. It looks great. I hope you put it to good use.

Re: Neat vise design

#4

Re: That's Easy

William Duffield

Build a meta-bench (a.k.a. bench-on-bench) around it.