New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Loose saw handle

Posts

Loose saw handle

#1

Loose saw handle

JasonInOC

I am cleaning up a Disston D7 of newer vintage. The handle was a little loose (towards tooth / towards back rotation) before I removed it. What is the recommended method of tightening the handle? It seems I can

1. Grind down the screws so they don't bottom out

2. Put washers under the screws

3. Put a shim next to the blade

These are newer screw-posts, not split nuts.

Also, what were the handles generally made of? Any advice other than strip the rotten finish and BLO it?


img

Re: Loose saw handle

#2

Blade

JasonInOC

Here is the blade after sanding with 220. The back side got naval jelly and a brown 3M pad, so it is cleaner. I didn't want to lose the etch on this side, though.


img

Re: Loose saw handle

#3

Re: Blade

Patrick Gibbons

Jason,

I find that naval jelly turns the steel a funky gray color. If you use mineral spirits as a cleaner with 320 grit sandpaper that will usually get rid of the rust and not really damage the plate. Others use wd40. If it has heavy rust you can first use a razor blade as a scraper. Your handle is made of beech. Unless your wood is warped, I think that just tightening the nuts down tight will take care of your problem. Without seeing the saw it's tough to say what else I might do. The side of the plate you showed looked nice. It will be a good user when you're done.

Re: Loose saw handle

#4

Re: Loose saw handle

Ron in Sterling, CT

I agree with Jason. Try to tighten the nuts enough to keep the handle from moving before attempting any of the other methods you suggest.

I would remove the old handle finish with sandpaper, then give it a coat of BLO, let it sit for a couple of days to fully cure, then spray on a couple of coats of rattle can lacquer. Finally, wax the handle, and the blade. Should make a good user saw.

Ron

Re: Loose saw handle

#5

Re: Loose saw handle

JasonInOC

I will try tightening the nuts, but I think they might be bottomed out on the screws.

I may have mis-typed, the blade in the picture is sanded 320 with mineral spirits.

Re: Loose saw handle

#6

Re: Loose saw handle *LINK*

Lars Parrington

Jason,

If you are going to strip and refinish the tote anyway, you might think about reshaping it. I like what Derek Cohen did to his miter saw handle here:


One reshaped handle coming up