New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Need more light at your bench?

Posts

Need more light at your bench?

#1

Need more light at your bench?

Bill Tindall

I just installed a new 4 foot x 4 lamp T5HO fixture above the vise. These units put out twice (20,000 lumens) the light of a T8 4 foot toffer yet take up a fraction of the overhead space. The light at the vise area doubled to over 400 ft candles. The finest scribe lines can be seen (but not necessarily followed).

I worried that there could be heat upon my head under the fixture. Could not feel any so that is not a worry. The price could be- $130. But that is not too great a price to pay for being able to see where the $150 saw is supposed to be sawing.

Re: Need more light at your bench?

#2

Re: Need more light at your bench?

Bill Houghton, Sebastopol, CA

Those T5 bulbs are, indeed, impresssive. I've got a much smaller T5 fixture over my bench, but, even though it's small, I get a lot of light from it.

Re: Need more light at your bench?

#3

On my list

Tony - Memphis

I have not noticed that I need more light, but I have noticed when I have more light, I sure like it! I have been surpsied whn using task lighting how much it helped. My shop is 16x20 and I have 8 twin 40W T12 fixtures. I thought that was a lot of light. I do get some shadows too. So, I'll look into the T5 options.

Tony

Re: Need more light at your bench?

#4

suggestions

Bill Tindall

You need at least 200 ft candles in a task area for detailed work. It took 14- 4 foot regular fluorescent tubes to get this level at my bench level (large bench area of 25 sq ft). For comparison, an out side shaded area will be 500 foot candles. I have an article in the Articles section on shop lighting and there is an excellent article in a recent version of the otherwise poor publication from Woodcraft. A fluorescent fixture should be mounted over the edge of the bench to avoid shadows and reflection.

Re: Need more light at your bench?

#5

Tube surface brightness can be decieving

Bill Tindall

The circumference of a fluorescent tube equals pi times the tube diameter. T12's are 1.5", T8 1" and T5 5/8". The tube surface being illuminated is therefore in proportion to the tube diameter. If each lamp puts out the same lumens, the measure of light output, the brightness of the tube surface will be in inverse proportion to the diameter. The T5 will appear much brighter than either the T8 or t12 , yet the same amount of light will fall upon the bench. This calculation assumes equivalent phosphors in each tube.

The way to get more light from a tube is to either up the wattage or use more efficient phosphors, which are more expensive or just not available for some colors. A typical T13 is 40 watts, T8 32 watts. The T5 HO (HO for high output) is 54 watts. The T5HO just has more hosepower(watts) to produce light.

If you want to know how much light a tube will produce look on the package and look for the "lumens" or light produced. This will be the vlaue when new. The light output degrades with time.

Re: Need more light at your bench?

#6

for the brightest, longest-lasting bulbs *LINK*

Patrick Gibbons

Go here and buy their bulbs. They do last 10 years and longer and don't diminish and yellow. Also they're much brighter to begin with. They are pricey.


Maintenance Engineering