We value your privacy.
We use cookies to enhance your browsing experience, analyse site traffic, and personalise content.
By clicking “Accept all”, you consent to our use of cookies. You can also choose
“Essential only” or learn more.
I thought I would be at this state some weeks ago. Then I realized that warm weather was getting rarer and I need warm weather to spray varnish on this chest of drawers, or at least the big part. So I have been busy finishing the case and now have a coat of varnish on it. The drawers, being small, can be done even in the winter as I can cure them indoors.
So now let the chisel smack down begin. Half the chiseling will be done with the PM11V LeeValley chisel and the other half with the home made CPM 3V chisel. I have arranged to get microscopy pictures of the chisel tips after use.
note: if the end grain looks strange it is because both drawer sides are nailed together so as to do both sides at the same time.
Is it poplar? will you have before picture also to ensure that even if similar sharpening sequences were followed the starting point was in fact the same?
Drawer sides are poplar, fronts are walnut and backs mostly poplar.
By the time I take the picture I will have chopped enough wood that it will not take but a 10X lens to see substantial alteration of the CPM 3V edge. It matters not the details of how it started. Other than ensuring that the bevel angles are equivalent I do not intend to go to the considerable trouble of getting a "before" picture. I expect, based on LV data, that the PMV11 may hold up better. But even if the LV chisel is close to the exceptionally tough 3V it will show that PMV11 is an exceptional chisel steel....or not.