New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

small butt hinges

Posts

small butt hinges

#1

small butt hinges

les winter

I'm going to build some small jewelry-type boxes. 3/8" walls, around 7.75x12x5" tall. I'd like to buy some decent brass butt hinges. The ones I have purchased from LV are brass-plated steel. The taper of the holes doesn't match the available #2 brass screws; the screw heads are proud of the hinges. I suppose I could get the appropriate taper reamer and grind the holes at a better angle. Or find a source of more narrow-taper screws. Seems to me, I should be able to buy hinges and screws from one source that work together.

If anyone has a source of reasonably-priced brass-plated hinges and screws which match, or a better idea, I'd appreciate hearing about it.

thanks

Les

Re: small butt hinges

#3

Re: have you tried Whitechapel?

les winter

Hi Bill.

I was trying to keep the cost substantially below $25/pair that White Chaple charges.

Re: small butt hinges

#4

Re: small butt hinges

rononkokomo

Try micro mark. Or hardware source

Re: small butt hinges

#5

Re: have you tried Whitechapel?

John in NM

I'm afraid you won't find a heavy brass hinge for under $20 or so. Prices have more or less doubled in the last 10 years between copper and fuel both going way up.

I've used some heavy ones from Woodcraft (7/8"x1 1/2") for small boxes, they are quite nice and still cheaper than Brusso, but they don't come with screws. Funny thing is Brusso haven't gone up at all, still $25 a pair -- that is what they cost when the other heavy hinges were more like $10

Re: small butt hinges

#6

The problem with hinges....

Bill Tindall

as described by the folks at Whitechapel. The demand for quality butt hinges waned and several manufacturers quite making them. Whitechapel had difficulty finding a quality supplier to replace traditional suppliers. Low demand, few manufacturers, leads to high prices.

Re: small butt hinges

#7

Re: small butt hinges

DizD

I do some small boxes on a production basis and have found ACE Hardware Medium Hinge Solid Brass to be a good performer. It has a tight hinge pin fit for the price - very little "slop" - and leaf thickness is better than some. Product # is 5299821 for one of the sizes.

One thing I do is design the box wall thickness a smidgen thicker than the hinge leaf width - then route the mortise all the way through. I also use the built in stop technique for lids - setting the hinge barrell flush with the outside of the box and chamfering the box and lid edge on the back side. A description of this mounting technique is on Whitechapel website under installing butt hinges.

Re: small butt hinges

#8

Re: small butt hinges

Warren in Lancaster, PA

Les, you ought to stop in at Ball and Ball in Exton. They are on BUS 30 near route 100, about 5 miles from the turnpike. Small hinges are about $13 a pair retail, manufactured and sold on the premises.

For adjusting screw holes, I use a hand drill and a countersink bit with 8 flutes (8 cutting edges). You can also use just a large twist bit, but it is not as nice.

Re: small butt hinges

#9

Re: small butt hinges

les winter

Thanks to you all for the good info.