New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Progress on chest of drawers

Posts

Progress on chest of drawers

#1

Progress on chest of drawers

Bill Tindall




These two pictures show the stuff involved in making the half dovetailed drawer dividers. A couple of points to make.

1. The desired precision for this joint is boggling. For stress-free assembly it should dry fit with modest hand pressure. I chisel it purposely tight. Any tiny over sized error and it becomes perfect. If it turns out a bit tight a shaving off the divider with a hand plane and it will be perfect. Editorial: I can't imagine why anyone would use a double tail in this application.

2. If the straight part of the tail socket is sawed perfectly perpendicular to the case side the divider will slip in and be perfectly perpendicular to the case side, a most desirable situation during assembly. Fitting drawers into a perfectly square case is easier.

3. A case made this way becomes a fortress of rigidity.

Re: Progress on chest of drawers

#2

Re: Progress on chest of drawers

Wiley Horne--So. Calif.

Bill,

Thanks for showing this again. It's beginning to make a believer of me. The case rigidity is certainly evident in these photos.

I have a couple of questions, and am hoping you will show the remaining case internal construction as you go along. If I am seeing things correctly, the half-dovetailed dividers are paired front and back--is that so? If so, what will the back consist of, and how will it attach? And also, what will the drawer runners look like--I'm speaking of the front-to-back sticks connecting the dividers that the upper drawer runs on and the lower drawer 'kicks' against--and how will they attach to the dividers?

Thanks,

Wiley

Re: Progress on chest of drawers

#3

answers

Bill Tindall

When I have closely examined case pieces in museums those that are assembled with the dividers simply mortised into the case invariably have the case sides pulled away from the dividers, more or less, while the dovetailed cases don't. Additionally, the half dove tails are self squaring if they are cut right and getting that cut right is trivial. With a bit of practice they go very quickly. I can chisel out the socket in just a couple of minutes and I cut the male part with the router in seconds. However, every operation is mirror imaged left to right so it is essential to keep track of the orientation of every cut. It is painfully easy to get a cut on the wrong side of the divider or case.


I have been making my case backs frame and panel and I simply screw them into a 1/2" rabbit on the back. Most of this wood comes from drawer making left overs.

The runners have tenons on the end that are loosely captured in mortises between the dividers. I make these from maple and they are one of the few things I hand plane to get a glass smooth surface which is then waxed.