New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

still workng on the dai

Posts

still workng on the dai

#1

still workng on the dai

eliot d

I've given up for a while on trying to post pictures: Iphoto stopped work for me altogether( something about an upgrade). (I have to go to the Apple store.)

I've gotten to the point where I'm fitting the iron into the abutments and the bed. I'd say the iron fits down about 2/3 way. It's going very slowly because I cut the abutments on the narrow side. I'm using that blunt chisel technique that I learned here. Just an old file that I ground a blunt edge on. It really does work! But slow.

Re: still workng on the dai

#2

Re: still workng on the dai

david weaver

Slow is safe. If there's not a lot of lateral room, just make sure you check lateral tightness while you advance the iron. I have made the mistake before where I removed material from the bed because of lateral tightness (not knowing that was causing a snug fit), but fortunately before I went too far.

Re: still workng on the dai

#3

Re: still workng on the dai

eliot d

Thanks. I'll check it today. By the way, if it is the bed and not the lateral fit that causing the tightness, is there anything wrong with taking a bit off the upper part of the abutments? There's a lot less wood there, and I don't care about a degree or two of blade angle. I've been resisting the urge to do that because I just figure that you're supposed to stick to the plan.

Re: still workng on the dai

#4

Re: still workng on the dai

david weaver

If the abutments are fitting the iron tightly, I would work with the bed unless you really have a lot to remove and doing so would open the mouth too much.

After you make a couple of the things, you'll probably just end up sawing the abutments a lot closer to finished size. I did the same thing on my first one, cut the abutments short to avoid overrunning anything, and then had a lot of work to do to get things opened up far enough. I did work the abutments and ended up undercutting them a little in the middle, but I don't think it was the optimal choice, because my saw cut was closer to the right fit to start.