Veritas steel honing plates
Bruce Mack
I am not in the league of others who post here on sharpening. Still I have seen no followups on this product since its release.
The plates are slightly rough to the touch, and vary from specimen to specimen. They are flat. I mounted them side to side with epoxy on 3/4 plywood. Tried mineral oil, lubricating oil, and WD-40 and prefer the latter for its consistency, thin but permitting easy side-to- side movement of the plane blade. Used as a unit, the 3 plates are weighty on my bench top where they live, and need no clamping in use.
I am very pleased with the results with side sharpening, no jig, and find that the final paste of 1 micron gives an exquisite edge that is not improved by chromium oxide stropping on masonite. The latter produces better shine but in my hands causes slight dubbing.
An occasional dab of paste on the end of a toothpick freshens the action.
The set up is accessible, right in front of me, and always ready (waxed paper protecting the plates from sawdust). I use it frequently and avoid the "maybe it's sharp enough" dilemma.
It's a fine product.




