New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Leather strop question

Posts

Leather strop question

#1

Stephen Shepherd

Leather strop question

Stephen Shepherd

I was having a discussion about strops with a friend of mine who is a professional woodcarver and keeps all of his tools with a mirror finish. He said that he uses strops with the rough side out and puts his abrasive compounds on the rough side.

Anyone else do it that way?

Stephen

Re: Leather strop question

#2

Re: Leather strop question

david weaver

No, but with abrasives involved, I doubt it makes much difference which side of the leather is used.

Re: Leather strop question

#3

Re: Leather strop question

Chuck Nickerson

I've talked with several serious carvers (perhaps not professional, not me) who put their honing compound on the rough side and use both sides of the strop.

Re: Leather strop question

#4

Steven Antonucci

That's how my strops are.

Steven Antonucci

I carve from time to time, and I have a strop in every kit I own. I glue the finished side to a wooden block and go from there. I have never seen a strop any other way, except in an old time barbershop with a straight razor.

It is no wonder so many old picture have men with beards...

Steve

Re: Leather strop question

#5

Re: Leather strop question

Stuart Hough

Stephen, as you know I am by no means an expert on anything, but I remembered something from my childhood about strops. My next door neighborwas a Master Barber who had the busiest shop in the town of Palatka, Fl. He had several strops in the shop, some of which he said were over 100 years old. He was proud ofthe fact that people came to him to learn how to sharpen their straight razors and knives. He would sometimes give strops away as presents to folks that had patronized his shop. He always talked of loading each side of the strop with a different compound to help in the polishing of his razors. He did have one strop that had one "rough" side. The strops he kept at the chairs were smooth on both sides. He said to get the type of edge that would shave the hair and give no irritation, you had to use the smooth side, and have it set up with the finest rouge you could get. That was the only way to get the kind of close shave he was known for. In my own experience, I use the rough side of leather for the initial polishing after sharpening, but I use the smooth side, loaded with extra fine rouge to get a mirror polish, and a scalpel-sharp edge, on my chisels.

Re: Leather strop question

#6

Re: Leather strop question

Patrick Gibbons

I know that Paul Sellers, a professional woodworker for forty years, uses the rough side with green compound for his stropping, which is an intregal part of his sharpening routine.

Re: Leather strop question

#7

Smooth side for my bench chisels, but

Bruce, a MN Galoot

I use the rough side for my carving chisels. They don't seem to mind getting dubbed over a bit. The bench chisels seem to behave better on the smooth side.