New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Stop cuts for a Long Rip?

Posts

Stop cuts for a Long Rip?

#1

Stop cuts for a Long Rip?

Texchappy

Got to thinking about this as I prepare to try to hand rip my second box side. If I cross cut stop cuts every so often along the length of the rip would that help me get back on track easier if I get off line. I figure if nothing else it would help me break it up for my energy level.

Good idea/ Bad idea?

TIA,

Tony

Re: Stop cuts for a Long Rip?

#2

Re: Stop cuts for a Long Rip?

david weaver

Bad idea. It'll make it harder to restart the cut easily and accurately, because your range of motion is biased now toward the side that's been hacked away. leaving the waste side of the kerf intact will help you make a more accurate cut.

Re: Stop cuts for a Long Rip?

#3

Re: Stop cuts for a Long Rip?

CStan

If you have a hard time tracking a line on a long rip then use a 22" crosscut panel saw. Mid-course corrections are always easier with a shorter saw and with a saw with a greater number of smaller teeth - like a 10 ppi or so panel saw.

If the project material is less than 3/4" thick (19MM) I'd rip with a crosscut saw anyway.

Re: Stop cuts for a Long Rip?

#4

Re: Stop cuts for a Long Rip?

Texchappy

At this point, I have the choice of two saws. A 12" combo filed tenon saw and a 210mm Gyokochu ryoba. I've done one with the ryoba so I may try this one with the western saw. It's a bit slow but I need to see how I get on with the western style. It's 1/2" poplar that I'm working with.

Re: Stop cuts for a Long Rip?

#5

Re: Stop cuts for a Long Rip?

CStan

Will the brass back of the tenon saw not get in your way?

Re: Stop cuts for a Long Rip?

#6

Re: Stop cuts for a Long Rip?

Texchappy

Now that you mention it. It will.

Re: Stop cuts for a Long Rip?

#7

Re: Stop cuts for a Long Rip?

CStan

Rip with the crosscut edge of the ryoba, especially since the material is thin.