New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

Setting up a stanley 39 dado plane

Posts

Setting up a stanley 39 dado plane

#1

Setting up a stanley 39 dado plane

Adrian

After failing to get two wooden bodied dados to perform I've turned to metal. But one thing has me puzzled. The cutting spurs are mounted in a sloped channel and they therefore stand proud of the side of the plane body. Am I supposed to try to adjust the iron in line with the edge of the cutting spurs? I don't understand why I would want the spur proud of the side of the plane body.

Re: Setting up a stanley 39 dado plane

#2

Re: Setting up a stanley 39 dado plane *LINK*

Larry Barrett

Adrian

I don't have a #39, so can't offer useful advice, but can provide a link to Patrick Leach's Blood and Gore, in case you haven't found this.


Patrick's Blood and Gore

Re: Setting up a stanley 39 dado plane

#3

Re: Setting up a stanley 39 dado plane

RobertHarrison

Not much response to this, so I'll take a shot at responding. As with all woodworking stuff, your mileage may vary and many ways to skin a cat, etc.

I always thought the nickers or cutting spurs of the 39 were too thick and extruded too far from the plane body on the stock 39 to be useful without grinding to a more knife-like profile.

I don't use them. I score the sides of the dado with a sharp marking knife, then cut the side walls on the waste edge sides with a backsaw and straight-edge guide, then cut the dado with the 39. Then use a small router to clean the bottom of the dado if needed (I prefer the Sargent router w/ 1/4 inch blade to Stanley), and then clean the sides with side rabbet planes, if needed (not often). Sounds like more of a process then it really is, and once you get going you can do dados pretty fast.

Re: Setting up a stanley 39 dado plane

#4

Re: Setting up a stanley 39 dado plane

Adrian

If you're going to cut the sides with a backsaw, why bother using the dado plane at all? Why not just remove the waste with a chisel and finish up with the router?

Is the spur arrangement on the stanley 46 the same?

Re: Setting up a stanley 39 dado plane

#5

Re: Setting up a stanley 39 dado plane

RobertHarrison

For me, when the blade is sharp and adjusted, it works very quickly to remove the waste going across grain. It seems like it would be much quicker than a chisel and possibly quicker than a router. It seems like it would be easier and quicker to "start" than a router, and more controllable than at the start and going to the desired depth than a router. It is still a great tool for me even though I don't use the nickers, or I have them set so high up that they have little effect. I view it as an essential part of cabinet-making or boat-building with hand tools.

Don't know the answer to the second question.