New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

First 'project' complete and some observations

Posts

First 'project' complete and some observations

#1

First 'project' complete and some observations

Texchappy

It started out to be a rough box for an old torque wrench. I got out my new ryoba to use it for the first time in anger. After my wife setting me up with a TV tray on the front porch as a temporary saw bench (and not a very sturdy one, I went to measuring.

First mistake, letting the three year old help me measure. Bad news = board too short. Good news = the ryoba performed superbly in the cross cut mode.

Well, the board I had gotten out to make my first box sides ended up with a large knot hole in the other end. I decided to do another project - a shelf that was missing from our small bathroom cabinet. I had tried about a year ago with a 1/4" mdf but that was too thing and ugly. I decided to use the knot holed poplar to fill that. Cross cutting again was a breeze.

The ripping proved to be a little more of a challenge. I but my old thumb up there to start it, tried a couple of pushes to start a kerf. Didn't really get a good start till I turned the saw over and made the kerf with the cross cut side. Then ripping on that wobbly tray proved a chore. I did it and figured out a couple of things along the way. It was too hard going closer to straight up and down so I had to saw with the blade just about horizontal. Also, somewhere along the way, I remember the old saw (hardy har) about letting the saw do the work. When I quite trying to put downward pressure I made a lot better progress.

Tip, critiques, etc welcomed.

TIA,

Tony

Re: First 'project' complete and some observations

#2

Re: First 'project' complete and some observations

Bruce, a MN Galoot

Working without a proper bench is hard, at best. If you don't have the room, at least get a Workmate for yourself. Folded up, it doesn't take much room. It's all I had for a bench for quite a few years. The first project I did, mostly on the living room floor, was to build an Aztec drum for my two-year old son, including chopping the dovetails. (I still don't know why my first impulse was to make a kid a noise-making toy.) Benches are nice; some might even consider them essential.

You have a good start on your project, though.

Re: First 'project' complete and some observations

#3

Bob

Re: First 'project' complete and some observations

bob

Compared to the results of my first projects, you have a natural gift for woodworking.