New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Breakthrough for me!

Posts

Breakthrough for me!

#1

Breakthrough for me!

eliot d

I know this is normal for most of you, but for me it's a new beginning. I followed David Charlesworth's book more or less to the letter and made a set of winding sticks. The first thing I tried them on was that Krenov-style smoother wood hand plane, about 17 inches long, that I made about a month ago. And sure enough, there was a slight wind along the sole. And when I looked more closely at the sole , I could make out a faint wear pattern consistent with what the winding sticks showed. So I'm in the process of flattening it out some more with sandpaper attached to a longish length of thick float glass. As I say, for me this is a new level of accuracy in my wood work. It's not something that I would have done before getting into this site.

Re: Breakthrough for me!

#2

Re: Breakthrough for me!

TomD

There you go, your skills are taking off! Next step when you are ready is to scrape or plane that wind out, not that there is anything wrong with sandpaper, I like it for plane flattening and a few other joints. Just more fun with the sharp stuff.

Re: Breakthrough for me!

#3

Re: Breakthrough for me!

eliot d

I kept trying to use sandpaper on a flat glass, but it was taking too long. So I did revert to a hand scraper. And it worked faster. I'm still too timid about my planing skills to try doing it with a plane.

Re: Breakthrough for me!

#4

Re: Breakthrough for me!

TomD

I use pretty coarse paper certainly not over 220, and maybe even 150. I normally use PSA paper on a jointer table. That will get the plane flat and you can do the finest work. Whenever you are sanding the paper should be noticeably effective, not clog. I normally try to use the coarsest paper I can. What exact number it has is going to depend on the type of paper it is.