New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Krazy Glue......

Posts

Krazy Glue......

#1

Krazy Glue......

Edward in Vancouver

Cats knocked over a favorite wood carving of my Dad's. It was "decided" that since I am the woodworker kind of guy that I should repair the statue--after my Dad unsuccesfully tried to glue it back with Krazy glue.

The statue is about 12" tall, probably maple or birch, of Mother Mary holding a baby Jesus. Both hands are broken off.

Hide glue would be a good choice, but how do I remove the krazy glue? Will acetone work on dried glue?

Re: Krazy Glue......

#2

Re: Krazy Glue......

Howard Pollack

I think so, if not there is "de-bonder" on the market. -Howard

Re: Krazy Glue......

#3

Acetone should do it.

John in NM

Only trouble is that it evaporates so quickly.

I would probably use hide glue to fix it - just the sort of thing you want to hold briefly then leave alone. Too much of a pain to try to clamp while the glue sets.

If you don't have any hide glue, you might be able to do the same with yellow PVA, though the initial tack with hide glue is much better.

Re: Krazy Glue......

#4

Re: Run a test.

TomD

Crazy glue. like the fine hot stuff LV sells, or the 4 tubes to a bottle the Dollorama sells, are ideal for this kind of repair. Crazy glue is the universal fix-it for wood turners, and luthiers, and certainly the luthiers are very familiar with hide glue. Advantage to hide glue, particularly had you been the first guy to the party, would be that it is reversible, and not likely to harm the piece.

My advice would be that if you are certain it is maple, or if you have a spot on the base where you can experiment, run a sample of the crazy glue followed by remover. Number one pro thing is not to guess. Always do a sample. Do it on a similar surface and grain orientation. If there was a clean joint it is hard to know why CG would not have worked, and if the parts assemble nicely, CG might still be a good bet. Before you switch to a different tack, you need to know what the result of using a remover will be.

For instance, most acetone contains trace oil pollution, so you are spreading machine oil on the piece if you use acetone. Does that decolor? Does it smear the residue over a wider area.

Everything should be fine, but you need to know, not guess, and tests are faster and more conclusive than even the internet.

Re: Krazy Glue......

#5

Re: Run a test.

Edward in Vancouver

Thanks for the responses. I'll be trying out glue on the base this weekend. Should be able to post some pics early next week.

Regards, Edward