IBC Plough PLane Blades
Derek Cohen (in Perth, Australia)
In a recent thread, Brian Rabinovitch, President / CEO of Industrial Blade Company Inc (IBC), mentioned that he had made the blades for Dan Barrett. I offered to post their pictures here for him.
Brian also answered a few questions about the blades in an email to me.
What steel have you using for them - A2 or O1?
A-2
what angle is the taper?
5 degrees from the highest point in front @ 0.325”thick to the back end @ 0.100”thick
What length are they overall,
8.750”tip to stern
and what widths go with the numbering?
No# 1 is 1/8” and No# 8 is 5/8”. I will have to get back to you with the other sizes.



Regards from Perth
Derek (about to have a shot at a Mathieson Bridled Plough)



