New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

oil stone glazing

Posts

oil stone glazing

#1

oil stone glazing

Jerry Gibbs

I have a small oilstone, approx 3x1x1/4". I was trying to sharpen a knife and the stone appeared to have a significantly smooth or glazed surface. Am I correct in assuming this detracts from the abrasiveness and is it correctable? I am aware the stone is cheap.

Re: oil stone glazing

#2

Find your friendly local sidewalk

Bill Houghton, Sebastopol, CA

or concrete block, and clean it up. Lubricate with water, rub vigorously. That'll take the glaze off and flatten it out right quick.

Re: oil stone glazing

#3

Jim in Burlington Ont.

Sandpaper

Jim in Burlington ON

You can clean it up and restore the surface with some sandpaper on a flat surface. Wipe the surface with your choice of solvent first to remove some of the grime.

Re: oil stone glazing

#4

What I did...

John in NM

Was take them to work and put them in the ultra-sonic cleaner, worked well. I think I used some isopropanol rather than water, figuring there was a lot of oily gunk clogging the pores.

For bench stones that were too big to fit in the cleaner, I boiled them in water for a while. Didn't work as well, but it was an improvement. I did this at work too, since I didn't want my wife to catch me boiling stones in her pans :D