New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

sharpening a hand scraper

Posts

sharpening a hand scraper

#1

sharpening a hand scraper

eliot d

I learned to sharpen these by first filing, then using a stone, then "stickering"( I think that's the term) , then burnishing. But I saw a demonstration where the guy only filed and burnished , and it seemed to work fine. What's the correct procedure?

Re: sharpening a hand scraper

#2

Jack Guzman from Maine

Re: sharpening a hand scraper

Jack Guzman from Maine

Just filing can leave irregularities. The stone just brings it down to a smoother finish. Probably not necessary with a fine sharp file if you file straight down the length of the scraper. I'm no expert ,just seems like common sense---Jack

Re: sharpening a hand scraper

#3

Re: sharpening a hand scraper

Paul M.

If I use a scraper to level finish, then I polish the edges and use the scraper without burnishing. That always works best for me on taking off the smallest curlies of finish.

If I'm scraping wood, then I usually just file the edge perfectly flat using a fine mill file, and then use the burnisher to raise a curl. I don't bother with the stones as it seems kinda pointless to me. I can get a good edge with the file.

After a dozen or so resharpenings, I will polish the edges again as they pick up nicks and wear along the way. But not for every time I raise a curl.

Heck, sometimes I just burnish the curl back down to flat and raise it again. Works for me if I'm in a rhythm and don't want to break more than a few seconds. But the curl will be fragile and it won't work for as long.

Re: sharpening a hand scraper

#4

Re: sharpening a hand scraper

TomD

Scrapers can be fluky to sharpen, but there are also lots of methods that work. Most commonly I just push them against a belt sander, and then burnish them. That may not be perfect but it is almost instant, which counts for a lot. But I have used the stones and all that, and the fact that scrapers are super cheap leads me to use the faster method, even if it takes away a little more metal.

Re: sharpening a hand scraper

#5

depends

ron in Kokomo

The finer the work I want to do with a scraper, the more time I spend preparing the edge. The closer I am to applying finish, the more I want my scraper as good as I can get it.

Ron in Kokomo G.O.O.N.