New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Simonds backsaw

Posts

Simonds backsaw

#1

Simonds backsaw

Edward in Vancouver

Picked up a Simonds backsaw, well, kinda.

Blued steel, one edge filed rip, the other filed cross cut. The plate fits in a frame, and can be slid up or down within the frame, or reversed. Tote has a very flat bottom to it.

I'm guessing it's used for cutting dadoes and/or a general purpose backsaw, but I can't find much information on it.

Re: Simonds backsaw

#2

Re: Simonds backsaw *LINK*

Bill Houghton, Sebastopol, CA

Sounds similar to the Disston No. 14 "backsaw" - look at the link below and scroll down a ways.

From Eric Von Sneidern's description, it looks like your instincts about dadoes were right - it appears the saw was designed for cutting to specific depths.


http://www.disstonianinstitute.com/backsawpage.html

Re: Simonds backsaw

#3

Re: Simonds backsaw

Edward in Vancouver

Thanks!

Very similar to the #14, but no wingnut at the toe, and the entire heel of the plate is filed with teeth--I'm guessing that the plate would be jammed into the tote along with the frame, to ensure the plate wouldn't slip down.

Looks like the saw was never used--or very little, teeth are still very sharp, etch is very clear, and no damage at all--or paint splatters! to the tote. No rust either.

According to the information I could find, Simonds stopped making saws in the '20's, and did have an office in Vancouver--and I'm guessing it specialized in logging equipment.