New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

Finishing the wood

Posts

Finishing the wood

#1

Finishing the wood

Derek Cohen (in Perth, Australia)

Three finishes that I swear by:

For flat surfaces ...

Feast Watson Fine Buffing Oil (the wax enriched version). I think that this is an Australian product. It is simply amazing. Wipe it on, wipe it off. Repeat. Leaves a rich finish. See the base of my new bench as an example.


Howard Feed-N-Wax: From the USA. Terrific wax finish, and even better rejuvenator of a tired finish.

On the lathe ...

Shellawax. There is no competition for this Aussie finish. Leaves Tru-Oil for dead. Buff one coat while wet, and it will dry and leave a clear, silky surface behind. Nothing more is needed (unlike Tru-oil, which requires several coats plus sanding between).


(No, I have not ignored Shellac. I do use it).

You?

Regards from Perth

Derek

Re: Finishing the wood

#2

Re: Finishing the wood

TomD

Tru-oil is designed for gun stocks, oil is pretty minimal for an outdoor use product to start with, the benefit is that they sink in a bit, or one hopes they do, sometimes all one is really seeing is a solvent wet out, and a resin wipe off. But if a finish can get into the wood that has some advantages. I worry about quick build and shine products they sometimes look great for a while, but I don't know of any that stand the test of time.

The only prepared finish that I use on natural wood with regularity is Watco. Just had a bad experience with that, but I think the wood must have been contaminated, it really took a long time to dry. There are several Watco's, including a marine finish, a wax, and stains, 99% of the time I just use the clear.

Other than that I make up Sam Malloof finish. I like it on tables and stuff that might water mark.

Guitars I French polish, or spray, or both.

It's like glue, I have dozen of different products for oddball situations.

Re: Finishing the wood

#3

Re: Finishing the wood

Patrick Gibbons

I got hooked on shellac and now feel it's an art that I'd like to be better at applying. Murdoch's tung oil finishes are also good for me.

Re: Finishing the wood

#4

Re: Finishing the wood

Tony Roth

Im sure this OSA dumb question, but why is the shellawax just for turnings? Wouldn't it be equally attractive as a table top finish, applied with a Rolex and felt or sheepskin pad? Thx t

Re: Finishing the wood

#5

Re: Finishing the wood

Tony Roth

Im sure this is a dumb question, but why is the shellawax just for turnings? Wouldn't it be equally attractive as a table top finish, applied with something like a rotex and felt or sheepskin pad? Thx t

Re: Finishing the wood

#7

Re: Finishing the wood

Derek Cohen (in Perth, Australia)

Hi Tony

Yes, a rotex would be a better choice! :)

I have done this myself. The problem is, however, that Shellawax dries quickly and as a result you cannot work large areas at a time. Boxes work well.

There are two forms of Shellawax, one is a liquid and the other a paste. The paste has a longer open time.

Regards from Perth

Derek

Re: Finishing the wood

#8

Re: Finishing the wood

Tony Roth

Thx Derek....