New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

wood movement

Posts

wood movement

#1

Jack Guzman from Maine

wood movement

Jack Guzman from Maine

I am building a table in red oak. The legs will consist of a 2x8 butt jointed to 2x6 for each leg.I will have 5/4 oak aprons mortised to the legs. My question concerns one of the 2x6s.I ripped an inch off the edge of it to bring it to finish width as it was 7" wide.This wood all came from the same source,bought rough. All pieces at 6% moisture content and acclimated to my shop. When I was ripping the board ,the board pinched.The cut closed up. The thin piece didn't curve as it came off. The 6" board ended up with just a slight bow to it. I could straighten it with one swipe from a plane.This is rift sawn wood. I planed this piece from rough and trued the face with winding sticks. The was no significant warpage to the rough board. Should I worry about this piece warping in the future?---Jack

Re: wood movement

#2

Re: wood movement

Brian Greene

Possibly. As I understand things, this occurrance is the reason for doing the milling from rough to finished size in two steps. You "open up" the wood with an initial milling, leaving at least half the waste for the second milling. The wood does what it wants to do as tension is released and the inside is exposed to the environment. Problems arising are corrected with the second milling. The wood should, all other things being equal, be stable at this point barring significant swings in moisture content. Bear in mind that cross grain movement due to moisture change is normal. Twist and warp are not.