New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

THE WOODRAT IS BACK!

Thinning Titebond Glue

Posts

Thinning Titebond Glue

#1

Thinning Titebond Glue

Barry

Sometimes, it seems that Titebond, out of the bottle, is just too thick for some purposes. I sometimes thin the glue with just a bit of water to adjust the viscosity. Also, as glue bottles approach empty, the glue seems to thicken and I thin with a bit of water. I have seen no indications this hurts joint strength or anything. Does anyone else do this? Any comments?

Re: Thinning Titebond Glue

#2

An acceptable practice

Bill Tindall

The makers of Titebond recommend thinning with up to 5% water for some applications, or when water has left the container either because it was left open or it is a very old container and some water was lost through the container sides.

They also caution that thinning the whole bottle with 5% water and forgetting this event and thinning again, and again , is not a good idea.

Thinning slows down the cure time for better or worse.

Re: Thinning Titebond Glue

#3

Re: An acceptable practice

Barry

Thanks.

Re: Thinning Titebond Glue

#4

Re: Thinning Titebond Glue

Paul M.

I've thinned titebond 1 quite a bit when using for veneering applications. No problems other than longer time to cure.

Re: Thinning Titebond Glue

#5

Re: Thinning Titebond Glue

Barry

I just wanted to be sure I wasn't committing some unpardonable woodworking sin. It hasn't seemed to cause any problems. :-)