New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Question for Derek

Posts

Question for Derek

#1

Question for Derek

Guillaume Dery

Hey Derek, next on my slippery slope is getting a bit more serious about my saws. I am doing well on most everything except my @##$% coping saw. Browsing through the board I saw an old thread where you waxed poetic about the KC fret saw. After 2 years, how do you still feel about the saw? Still tops on your list? Aluminium good enough? Will mostly be used for removing waste for dovetails in my case. Will stick to a bowsaw for most curves.

Enquiring minds want to know.

Cheers,

Guillaume

P.S.: The bench is looking all kinds of awesome. I am sure you will be overjoyed with it!

Re: Question for Derek

#2

Jack Guzman from Maine

Re: Question for Derek

Jack Guzman from Maine

Hello Guillaume,

I'm not Derek but I felt like responding to your post. I don't like a coping saw for cutting dovetail waste.I find it too big and clumsy.I use a small jewellers saw. With mine I can turn the blade sideways in the frame.Also it holds thinner blades than can fit in the coping saw. I like the look of that saw Derek reviewed but it's too pricey for me.---Jack

Re: Question for Derek

#3

About the KC Fretsaw

Derek Cohen (in Perth, Australia)

Hi Guillaume

Many thanks for all the kind words and suggestions.

The Knew Concepts fretsaw is excellent and nothing else I have tried to date comes close. I was using it to remove the waste in the bench endcap, the section thickness involved being 3/4". It did this with control and ease.


I have praised it on the forum, and also did so in a review I wrote. This traced the development of the fretsaw ...

http://www.inthewoodshop.com/ToolReviews/KnewConceptsFretsaw.html

I have been spoiled in that I have only used titanium versions and not the aluminium, and all mine were supplied as part of an ongoing design/development process. I believe that the aluminium version is nearly as stiff as the titanium. At half the price ($95 I believe), it is the one I would get if I was paying for it out of my pocket.

Do I recommend the KC fretsaw? Absolutely.

Regards from Perth

Derek