New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Installing a Pattern Maker's vise *LINK*

Posts

Installing a Pattern Maker's vise *LINK*

#1

Installing a Pattern Maker's vise *LINK*

James Watriss

Finally got around to writing a more coherent install article, for this who are interested. Next project is a tips and techniques page...


Installing the Emmert Vise

Re: Installing a Pattern Maker's vise *LINK*

#2

Re: Installing a Pattern Maker's vise

Guillaume Dery

Of course you realize that some of us who don't have/can't find an Emmert or didn't get around to getting the Tucker while it was still being made/sold are terribly jealous...

Merry XMas

Guillaume

Re: Installing a Pattern Maker's vise *LINK*

#3

Re: Installing a Pattern Maker's vise

James Watriss

Well, yeah.

But I've seen and played with the smaller Chinese made pattern vises, and while the edges could stand a little bit of knocking down, the product overall was remarkably not bad. I installed one on a scrap of butcher block for a display, back when I worked at Woodcraft.

But, lacking suitable installation direction, they very rarely sold. My impression was that folks thought they were intriguing, but looked complicated to put in. My experience is that they're more labor-intensive than the simpler vises, but nowhere near as hard to install as I thought.