Re: Installing moldings
Warren in Lancaster, PA
This does seem tedious. I have never used clamps and probably the guy who made the old piece did not have very many clamps either.
Starting with a full length moulding, I cut the left side mitre so that the left side is maybe an inch too long. Then I mitre the other side of the left front corner. Next I hold the two pieces together at the left front corner to position the front and mark the right corner (the length of the front) with a knife. From that mark I cut the right mitre on the front piece, then cut the other mitre on the right side piece.
Then I hold the left side and front together to position the front and nail the front on. And last, I hold the left side up against the front corner so I can mark the length at the back and do the same on the right. All the marking is done from the case and only six cuts are made.