New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Gluing drawers in place question, Andrew?

Posts

Gluing drawers in place question, Andrew?

#1

Gluing drawers in place question, Andrew?

Bill Tindall

Did I understand correctly that the drawer is not fully closed in the case during the glue curing time? Is this detail to preclude the risk of the drawer gluing itself to the case, or some other reason?

I have been capturing a thin piece of plastic between the frame and side of the drawer front where there could be a thin film of unhardened glue. These two strips also center the drawer in its opening. Do you do any wedging of the drawer in the back to center it in the opening?

Re: Gluing drawers in place question, Andrew?

#2

Just straight in, Bill

Andrew F in Australia

Hi Bill,

No plastic, just make sure that there's no glue left on the outside of the drawer.

Yes, it's left proud of the opening but parallel to the drawer rail so that you don't glue it in.

I just press the drawer up against one guide to ensure that it dries parallel to the opening.

CHeers,

Andrew

Re: Gluing drawers in place question, Andrew?

#3

question

Bill Tindall

How long do you leave a drawer to "cure' before you feel the glue is sufficiently cured to do fitting(by planing)?

Re: Gluing drawers in place question, Andrew?

#4

Time depends on the glue, Bill

Andrew F in Australia

Wait until it's gelled completely on the outside. Anywhere before two and ten hours, depending upon the ambient temp.

Of course, 24 hours is better. Rarely are you in that much of a rush.

Cheers,

Andrew F