New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Glueing up.

Posts

Re: Glueing up.

#26

Re: 1 side vs 2 sides and Norm

TomD

I do think there are two reasons to do double glue coverage. 1 is that with certain fits the glue will get pulled back from an edge. So in the dovetail example, the glue if say put on the end of the pins will get pulled back as the pins penetrate the sockets, and the glue coverage will not be even. The addition of glue to both pieces will allow the coverage to be more even. And in some cases, the addition of extra glue will not affect a thing, so why not. I don't think it is a fundamental, you can get good results a number of ways, it is normally a mater of working it through, or copying someone else's method in toto. Certain decisions will not work if all mixed up, there can be a given recipee, that works best.

The other reason for doing both surfaces is to get good coverage. This can be a process thing, or a tools thing, or a glue thing. You just have a foolproof double surface approach that never fails, good enough. But then so to is some other approach with the same outcome. There just are certain cases where coating both surfaces is a back-up and worth the effort.