New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Coming soon-diamond plane blade

Posts

Coming soon-diamond plane blade

#1

Coming soon-diamond plane blade

Bill Tindall

We recently had an A2 plane iron coated with a diamond coating. The advantage of this coating is that it is done at low temperature and the steel won't soften during coating as is the case with the conventional TiN process. Also in this case a bevel up plane will be used for evaluation, a case where the coating is expected to be more effective than coating a bevel down plane configuration. Wear evaluations will be done by our WoodCentral expert in these matters, Steve Elliot. Stay tuned for more results on this blade as well as new pictures of the TiN blade.

Re: Coming soon-diamond plane blade

#2

Stephen Shepherd

What do you sharpen it with?

Stephen Shepherd

Re: Coming soon-diamond plane blade

#3

Diamonds

Neal in San Jose

Back in the day, I worked for General Electric when they were developing "Compax", which are carbide insert tools with a thin layer of either diamond or Borazon (cubic centered boron nitride - the second hardest thing known). To grind these tools, we used a surface grinder with a diamond impregnated wheel. The diamonds in the moving wheel have more energy, and will cut the stationary ones. The wear rate on the grinding wheels was impressive, even so.

So, we may need to develop a sharpening technique that uses briskly moving media instead of moving the blade.

Re: Coming soon-diamond plane blade

#4

Re: What do you sharpen it with?

Steve Elliott

The diamond layer on the blade is 2 microns thick. I'll be using fine diamond on cast iron to sharpen the blade, working on the bevel side only, which has no diamond coating.

Re: Coming soon-diamond plane blade

#5

Re: What do you sharpen it with?

Peter Evans

I purchased a single bevel diamond coated German kitchen knife many years ago; I wonder why it was a deeply discounted "special"). Did not work for long, eventualy I ground off the remaining diamonds (lots had already gone) and had a good knife

Re: Coming soon-diamond plane blade

#6

Success is assured.....

Bill Tindall

unless the post office looses it, for the objective is to see what happens when this blade planes wood. Steve has the capability to gain this knowledge. Some will find the knowledge gained interesting. There is a small chance that someone may even find the knowledge profitable. While others will be stimulated to consider reasons we should not have made the effort. A penny for the thoughts from Lee Valley............

Re: Coming soon-diamond plane blade

#7

How did you like eating them? (:

Pam Niedermayer - Austin, TX

Re: Coming soon-diamond plane blade

#9

that is the solution

Bill Tindall

"a CVD diamond cutting insert polished in this way is suitable for mirror-finish cutting"

As I understand the discussion the plasma etching was used to image the damaged surface. I will track down the polishing details. thanks for the reference

Re: Coming soon-diamond plane blade

#10

Re: How did you like eating them? (:

Peter Evans

I did not notice any taste, but I was mentally sharper.

Re: Coming soon-diamond plane blade

#11

Re: Success is assured.....

Rob Lee

Hi Bill,

Will watch your results with interest... ;)

Cheers,

Rob

Re: Coming soon-diamond plane blade

#12

I was thinking grit, but 

Pam Niedermayer - Austin, TX