New WoodChat!
Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Krenov style saw horses

Posts

Krenov style saw horses

#1

Krenov style saw horses

Bill Tindall


I must have some Missouri blood because I often need to be shown something before its utility becomes apparent. To that end I was in David Finck's (the plane person) shop and didn't stumble on some Krenov style saw horses, unlike mine whose legs splay out. Their utility instantly became apparent- light weight, strong, easily moved and stacked.

I buy a few hundred bdft of #2 common oak and poplar from time to time for needs such as this and had on hand a white oak board 12' x 6" which just made 2 horses 30" high, 22" leg and 20" wide. It was even spalted, a defect everywhere except modern furniture, which was why this otherwise nearly clear piece was graded as pallet lumber.

I made the horses as those of Finck's- through tenon for the middle stretcher,and bridle joint screwed for the top stretcher. However, I made them too robust. The pieces are 3" wide but 2 1/2" would be more ideal for all but the foot. They will be employed at once on a diminutive cherry chest of drawers I have under way for a small grand daughter.

Re: Krenov style saw horses

#2

Nice, and a nice design

Bill Houghton, Sebastopol, CA

Re: Krenov style saw horses

#3

Re: Krenov style saw horses

Pam Niedermayer - Austin, TX

They look very nice, and a lot easier to build than western horses.

Pam

Re: Krenov style saw horses

#4

Re: Krenov style saw horses

Bill Tindall

yes and an opportunity for stress-free (presuming you don't flaunt your saw horse joints) practice making M&T joints. I found this oak board with its stringy grain to be an aggravating material to chisel and brass would have been softer to pare.

Re: Krenov style saw horses

#5

Re: Krenov style saw horses

TomD

Easier? Really. Most Western ones just nail together.

I built a set of these X years ago. At the time, the biscuit jointer had just come out in america. I was curious to see how strong the joints would be so I made the M&Ts with the biscuit jointer. Not really a good application for biscuit joints. But, they have stood up. I used two of them as supports for my trimaran main hull when it was hanging from a deck jig during construction. I used two 50 gal barrels at the other end. Even with the biscuits they were amazingly strong, but after about 15 years of intense abuse I had to reglue the joints. They are as good as new again, and will see me through, which is almost too bad given that I never had the fun of making the M&Ts.

While they are great, they take up quite a bit of space, and the feet can give you a nasty dig if one isn't careful. Mine are pretty much as awkward as Bill's with a lot of sharp corners. I see various versions with a little more grace, and a little less tooth and they might take less skin. Some of these are almost a little delicate. Mine are hard rock maple with some oil finish.

Re: Krenov style saw horses

#6

Re: Krenov style saw horses

Pam Niedermayer - Austin, TX

Cool, wonder what Krenov would say about using biscuits in his design?

Pam